Showing posts with label Carl Siefert. Show all posts
Showing posts with label Carl Siefert. Show all posts

Wednesday, July 8, 2020

Saga of Sorts My Early Bike Riding


Westside Historic — westside-historic: Santa Monica High School seal

During Junior High at John Adams I started working at Cycle and Sports in Santa Monica. It was summer time and I got to open the shop and put up the awning. Sweep the floor and put things away.
The shop was ran by Ernie Zamora and was a family business. Ernie's father and brother Eddie came in to the shop occasionally and the family lived in Santa Monica in a big house north of Wilshire.Heathers | Film Locations


The kid that did the bike repairs was Carl Siefert. Carl was 4 years older than me and he lived down the street at 6th and Broadway in a wood framed house. Today you would find it hard to find a small house to rent in that area so close to downtown at Third Street. Carl was going to Samohi (Santa Monica High School) and was also attending summer classes so he go finished school and help support his family.
Carl was a racer and was missing his front two teeth after crashing at the wooden track in the Valley (wasn't there when I started). He had a black AutoMoto with two sets of wheels. One set was clinchers for training with a single cog in the back and the other had sew-ups for racing. Collecting the vintage racing bicycle

I was still riding my 26 inch balloon paper route bike. Earlier I really wanted a Schwinn Varsity with a three speed but that never happened.

I not sure as I was not keeping notes at the time but I came up with a red Schwinn frame with 27 inch wheels and a rear shaft shifter and hand brakes, This bike was so different, so much lighter and faster. My first grand tour was to ride from where I lived at 10th and Olympic Blvd. to the Los Angeles Air Port on Century Blvd. I rode on Lincoln Blvd up and back.

At the corner of 9th and Olympic there was the corner liquor store and there I met this guy who was a cyclists and he asked me if I wanted to go for a weekend ride and I said sure. Little did I know what a weekend ride was. Saturday we left and went to PCH and headed up the coast towards Topango. He told me to follow Topango over the hill and take Ventura Blvd to Beverly Glenn  and come back over the hill to Santa Monica Blvd.

He took off over Topango leaving me behind and I followed his route plan. I have no idea how long it took me and how many stops for soda I took probably most of the day. The ride down Beverly was so scary and fast. I was hooked.

Then I got my Schwinn Paramount from my friend Larry Niles who lived in Los Angeles and visited his grandmother on Tenth Street. After working for a year at the bike shop I was able to buy a Italian Arbos Road Bike using my employee discount. The retail price was $135.00. Arbos 50's - BikesRetro


So I had the Arbos and the Paramount frame. I rode the road bike and slowly built the track bike. In bike racing there were two classes: Juniors 16 and under and Seniors. Most of the road races in Southern California took place in the Santa Monica Mountains and some were in the valley. There were not any criteriums. Track racing took place on the streets that were closed. The Rose Bowl was used and the strip next to Long Beach Stadium. Rose Bowl Stadium - Pasadena | Visit Pasadena

Even in the fifties there was a division between trackies and roadies. Roadies trained by themselves or in small groups and the track guys in Southern California rode twice a week by Griffith Park next to the Los Angeles River. Carl had a car but we rode the track bikes from Santa Monica to the Park area with our stiff hubs and no brakes. When the sprinting was over we rode back in the dark. I did have a front mounted brake on the Paramount I used when riding around town with my friend Bill Morris who also had a fancy Paramount he bought from a fellow named Tony that worked in the bike shop in Westwood.

We rode these track bikes around town long before there ever was any fixies. Carl stayed at Cycle and Sport then left and went to another shop and I stayed behind as his replacement. When the two of us worked together we would ride each lunch hour leaving the shop headed to PCH then up to Sunset going east then looping back to the shop. PCH is flat and usually you ride into the wind with only one signal then at Santa Monica Canyon. Sunset is rolling hills and Carl and I would sprint to each white line traffic crossing. Carl was super strong, one of the best, and I was a skinny kid trying to keep up. CONTACT — CostaLaw

Carl moved from Broadway with his family to north of Wilshire where he had a garage on the alley. Carl was not only a great bike rider he was also a avid hot rodder.
His Battered old Relic Turned out to be a 1932 Ford 3-Window Coupe ...

 One summer he drove his 1932 three window couple Ford  back to Xenia, Ohio to visit his grandmother. We also had a friend that rode and was also a car nut. Carl's sister lived in Fontana and several times we drove there searching barns looking for old cars. Once we actually found a hay covered deuce in a real barn. Carl bought it for Jim who had it hauled back to Santa Monica where it was placed in Jim's garage behind the apartments on Ocean Park Blvd. Jim was working for General Telephone in the summer while he attended USC in the fall. Jim also had a 1956 650cc Matchless twin. That was my first ride on a motorcycle.
1961 Matchless G12CS
If you plan your life in detail you will miss the strange curves in the road. Bill Morris lived off of 11th Street past Ocean Park Blvd. His mother like so many in Santa Monica worked at General Telephone where the corporate office were located. I also applied for a job there once. Bill had a brother Bob that had a 53 Chevy and a 5 widow 32 Ford couple. Bob joined the Navy and Bill's mother wanted the coupe  removed from the driveway so Bill, Tony Reyes and I pushed it across town (no motor) and put it in my father's garage. The garage was under our house and was huge. My father built a shooting range there where we could shoot our 22s.

Carl took me to the road races in his 39 Yellow Ford Coupe with the giant trunk. 1939 Ford Deluxe Coupe | S84 | Dallas 2017My first race was in San Diego at Torrey Pines. I was the only junior there as bike racing was mainly an adult thing. In the race I rode against Bill Disney who was Jack Disney brother. Both of the Disney brothers were skate guards at the Polar Palace Ice Rink in Hollywood. I used to skate there on Sundays but that is another blog.

When I was turning 16 I bought Carl's Yellow 39 and got my learner's permit. Carl was a welder and had added cut out pipes to the twin exhausts on each side. The cutouts were not capped with bolted plates as Carl used gas tank fillers with the original screw on caps. This allowed you to open the door and reach down and unscrew the caps making lots of noise. The 59A was basically stock with one over bore and a set of Navarro heads. It did have an electric 6 volt fuel pump and later three carbs were added. The hood rear mounts were removed so we could take off the hood easily as we were also working on it. The cooling fan had been removed which made it over heat at times. My good friend Don Vesco once said, "Flat heads were only good for boiling water".

I stopped working at the bike shop and got a job in a plastic factory by the rail road tracks on the same street I lived on Tenth. This kinda stopped my bicycle riding for several years. Sixty four years later I still have the Paramount. Carl kept riding and his training became extreme. He worked at a bike shop in Canoga Park and lived in Santa Monica. He would drive his car to PCH and Topango where he would park the car and ride to work over the hill. Then ride back in the evening. Several times I rode by track bike to the top of Topango and waited for him where we rode back to his car.

Carl went to the Olympic trials one year in San Jose but never made the team. Not because he wasn't fast enough but he slept in his car before the trials and didn't wake up in time. Carl then decided he wanted to become a flyer so he joined the Army and left me with  his 40 Ford Couple that had a 8 inch chopped top all custom Barris. Carl and I belonged to the T-Timers the local hot rod club.

 Dick Gish was the president of the club and he raced a 32 high boy with a 296 flat head on fuel at El Mirage. My first trips to the dry lake was as a member of Dick's crew. The lady next to Dick's house had gotten a divorce and the husband left the chopped forty behind. It had no motor and set so low to the ground in the rear it could only across a driveway ways. Carl bought it for $100.00.


The Forty never looked like this one in the picture. The grill was narrower, no skirts and the rear end was higher up.

This Blog started going in one direction and got lost.



Monday, December 24, 2018

My Bob Jackson

I have several bicycles. Maybe too many.
This Road bike was purchased in 1978. I was working in Santa Monica at a customer site and on the drive back to Orange County I stopped by a bicycle shop on Wilshire Blvd.
I don't remember why I was at a customer site as I have several customer service people who did most of the field work.
I was such a sucker as I walked into SuperGo not really needing another bike. I had a MotoB a French bike with sewups that always would flat. Then I was mostly running a lot maybe eighty or ninety miles a week.
I was living in Mission Viejo on the golf course and still had my house in Lake Forest that was either rented out or my daughter lived there, not sure.
So I wandered around the bike shop and spotted two frames on a rack that were too sweet. Don't remember the other (curse of old age) but the Jackson had leather handlebars tapes and had been just put back on the rack after appearing in the LA Bike show.
Not sure how I paid for the Jackson as then I had an American Express Card and did not use other credit cards. Anyway I bought the Jackson and took off the wheels and put it in the back of my Corvette. I was driving a 1977 350 with a T-Top. 
The frame was not white as shown and had a set of alloy sewup wheels. Those wheels were good for several years until the spokes kept going loose. Plus I would ride around El Toro Air Station and get flats and walk back or hitch a ride in a truck. Once I flatted down my Laguna Beach and walked several miles barefoot, you can not walk in old style cleats.
Actually you can not walk far in new cleats unless it is a MTB pedal. My office mate used to drive out at times and haul my ass back to the office so I decided to buy a set of clinchers for the Jackson. 

I moved to another house in Lake Forest and still kept the bike. By now the top tube was chipped so I covered the bad spots with decals. I has always been a roller rider since maybe I was 14 and got the rollers from the bicycle shop I worked at in Santa Monica. Riding the rollers with the Jackson cause my sweat to drop on the top tube and it started to get rusty so I put my son's bike decals on it. My mentor Carl Siefert  taught me to ride the rollers. I lived on Olympic Blvd then and would listen to AM radio playing Dixie Land Jazz while riding.
One day when I was out riding the Jackson while I still lived in Lake Forest a young female rider came along next to me an told me "Steel is Real", that made my day. I had a good friend named Clark that ran a front end alinement business and he showed me his bike that he had bought from an Olympic Gold Medal winner. Clark wasn't riding any more and I really like his bike with the carbon frame and other stuff. 
So the Jackson retired for several years. But it was not forgotten.
The carbon frame was ridden a lot but when I moved to South Pasadena the Los Angeles streets started to crack the frame. I still have the frame in my locker is San Pedro but got another road frame to replace it.
While I was living in South Pasadena I decided to paint my 1938 Schwinn Paramount and after that I painted the Jackson. I masted the head badge and decal and the chrome tips were covered. My paint choice was a poor one as the paint never set very hard. 
The Campy wheels were off another bike I was given after my boat was hit by a neighbor. Another story. The wheels came without cogs and all my stuff was Shimano. After an ordeal on EBay I finally got a working wheel set.

The OEM pedals were replaced at one time with 9/16 newer pedals using an adapter but have now been restored to the real ones. Getting cleats for newer shoes and older pedals was also a problem but I have plastic cleats that use modern shoe patterns but still use the old pedal.
Yes after forty years the brakes really work. Probably better than the rider.